Note: Before you plug the camera module into your computer, make sure it is on a non-conductive surface. You’ll want to test the camera itself on your computer – we test all the cameras before shipping, but to remove any doubt, you should test it before installation. The camera mount has a swivel design with knobs on both sides that can be loosened while adjusting the camera mount and then tightened once you find the correct angle needed to see your laser bed. We’ll cover the Official LightBurn Camera Mount in this guide since any mount you design and fabricate on your own may differ in operation. 3D print the Official LightBurn Camera Mount (Download STL Files).Purchase the Official LightBurn Camera Mount.There are a few options when mounting the camera to the lid.

You will need to put the camera into an enclosure to protect the electronics on the circuit board. The connector cable will need to run from the camera to a USB port on your computer so LightBurn can connect to the camera. This document will cover mounting the Official LightBurn Camera for use with your laser.įor a typical K40 or small laser the camera will need to be mounted on the inside lid of your laser and be able to see the bed when the lid is open.

Lightburn alternative